bolt length

I need to output  the length of bolts in inches, but lengths above 12", the answer is 1'0 (ft/in).

Is there any way to output it in inches?

Hi Norberto Muchuelo!
Please question the display parameters by command line.
Open the command line and write this commands below:
Q DISPLAY
Then post the result here in PdmsWorld.
When you post, please send me an email
then i come back to try to help you.

Bye.

Hi Andrews,

The componet list in isometrics has the bolt length in feet / in.
I need to output them only in inches.

IE, 14.3/4" is listed as 1' 2.3/4"

The options file has the default units for bolts as "Bolting  Units  IMP"

My question is if there is a way to have it in inches.

The difficult I´ve been trying to avoid is the fabrication/erection  personnel are not familiarized with this type of units.


Norberto

Hi
modify it in design module.
goto settings>units...  and select your units then goto isometric and getwork.
then do the iso.
good luck.