[QUOTE=rian;102878]yup already do it .
assumption ,flg1+gsk+vlv+gsk+flg2.
default bsel on spec was 'A'
insert bsel 'W' on flg1 and valv it will appear spref from Bsel W but on flg2 will miss bolt.
insert bsel 'W' on flg1 ,it will appear spref from Bsel A on flg2 but on flg1 will miss bolt.
are any possible we can put two type bsel on Valve?
regards
rian
Ok rian
I got it.
One possible solution:
You know that at BTSE (or BLTP) level you can specify bolt length using one (or more) category parameter (expressions are accepted).
This will one of the factors that will affect the total length calculation.
Let's say that you set that bolt length to something like PARA2 + DESPARA1
In Design, if DESPARA1 of FLANGE is set to ZERO, then you will get normal total length.
If you need a longer total length you just need to change DESPARA1 to, let's say, 50mm
Hope this make sense to you.....and most of all.....I hope it will work!
;-)
[QUOTE=rian;102878]yup already do it .
assumption ,flg1+gsk+vlv+gsk+flg2.
default bsel on spec was 'A'
insert bsel 'W' on flg1 and valv it will appear spref from Bsel W but on flg2 will miss bolt.
insert bsel 'W' on flg1 ,it will appear spref from Bsel A on flg2 but on flg1 will miss bolt.
are any possible we can put two type bsel on Valve?
regards
rian
Ok rian
I got it.
One possible solution:
You know that at BTSE (or BLTP) level you can specify bolt length using one (or more) category parameter (expressions are accepted).
This will one of the factors that will affect the total length calculation.
Let's say that you set that bolt length to something like PARA2 + DESPARA1
In Design, if DESPARA1 of FLANGE is set to ZERO, then you will get normal total length.
If you need a longer total length you just need to change DESPARA1 to, let's say, 50mm
Hope this make sense to you.....and most of all.....I hope it will work!
;-)