[QUOTE=pitch;49318]Corrado is correct. My mistake, (must be an age thing)
I have just tested it out and if the two flanges have the same BLTREF then the NSTDBLEN is not used and the Length of the SBOL is output.
In fact it will output the Length of the SBOL if the Length is not in the NSTDBLEN table
It also works even if NSTDBLEN is unset.
As for documentation, there has been no documentation for OLD Bolting since NEW bolting was introduced with Version 11.1 in 1997 (14 years ago).
So you will need to find something from Version 10.5 or earlier.
That is one of the reasons that I say OLD should be abandoned.
Where is the new bolting method is documented?
[Old bolting method]
the oldest version that we've is 11.5. So,could you please send me the documentation of version 10.5?
[QUOTE=pitch;49318]Corrado is correct. My mistake, (must be an age thing)
I have just tested it out and if the two flanges have the same BLTREF then the NSTDBLEN is not used and the Length of the SBOL is output.
In fact it will output the Length of the SBOL if the Length is not in the NSTDBLEN table
It also works even if NSTDBLEN is unset.
As for documentation, there has been no documentation for OLD Bolting since NEW bolting was introduced with Version 11.1 in 1997 (14 years ago).
So you will need to find something from Version 10.5 or earlier.
That is one of the reasons that I say OLD should be abandoned.
Where is the new bolting method is documented?
[Old bolting method]
the oldest version that we've is 11.5. So,could you please send me the documentation of version 10.5?
