[QUOTE=corrado;64231]I guess you are using the NEW bolting method, aren't you?
Navigate to your valve SCOM.
As Pitch was saying, youn need to set its BLRFARRAY attribute in order to point to two different BTSE.
I.e. BLRFARRAY /AAVGBB2-8-20 /AAVGBB2-4-20
Then in your spec you just need one entry for 20mm diameter bolt:
HEADING
TYPE NAME BDIA BTYP CATREF DETAIL MATXT CMPREF BLTREF
DEFAULTS
- - - STUD
BOLT */20mmSTUD 20.0 STUD /STUD /STUD-D /STUD-M =0 /ABGABYes but the BLTREF /ABGAB points to a SBOL where the NOFF is set to either 4 or 8 but not both.
[QUOTE=corrado;64231]I guess you are using the NEW bolting method, aren't you?
Navigate to your valve SCOM.
As Pitch was saying, youn need to set its BLRFARRAY attribute in order to point to two different BTSE.
I.e. BLRFARRAY /AAVGBB2-8-20 /AAVGBB2-4-20
Then in your spec you just need one entry for 20mm diameter bolt:
HEADING
TYPE NAME BDIA BTYP CATREF DETAIL MATXT CMPREF BLTREF
DEFAULTS
- - - STUD
BOLT */20mmSTUD 20.0 STUD /STUD /STUD-D /STUD-M =0 /ABGABYes but the BLTREF /ABGAB points to a SBOL where the NOFF is set to either 4 or 8 but not both.
