Issue, one pipe, two branches, each branch have a pair of flanges. Branch A's flanges has BSEL A and branch B's flanges has BSEL B.
If I run isometric on branch A, I get correct A bolts, nuts and washers
If I run isometric on branch B, I get correct B bolts, nuts and washers
If I run isometric on the pipe, I get A-bolts with A-mateiral and B-bolts with B-material, but all nuts and washers are of A-type with A-material (A is the first branch in flow)
I have the same pipe layout, but only 1 branch, and get the same results
A third test pipe has different sizes of flanges but same bolt diameter, and now when I run the isometrics, I only get bolts, nuts and washer from the first bselector...
BUT. If I query the flanges, q pa bolt 1 spref / rtext et.c.c I get the correct output....
Hey h3nrik, can you explain in more detail your solution for this "..naming of the SPCOs was the error."
My name for SPCO are:
BOLTING/STUD_2Nuts_HH_2Washers/0.50:A
BOLTING/STUD_2Nuts_HH_2Washers/0.50:B
Thanks h3nrik, it worked like:
[COLOR=#333333]BOLTING/A/STUD_2Nuts_HH_2Washers/0.50
[/COLOR][COLOR=#333333]BOLTING/B/STUD_2Nuts_HH_2Washers/0.50[/COLOR]
The reason is that the :A and :B are stripped off when summing the components. This results in the same "stripped down" SPCO name but the description is taken from the first of the components encountered.
The reason is that the :A and :B are stripped off when summing the components. This results in the same "stripped down" SPCO name but the description is taken from the first of the components encountered.
