[QUOTE=zion;106313]I assume this is using new bolting method.
AFAIK there is no control for the rounding of bolt length calculation, as it will always round up to the nearest bigger value in your bolt table.
I think you can play with the thickness of the gasket, use dataset for its default thickness value. then you can subtract the desparam from the thickness of the gasket to get the desired bolt length.
Cheers,
Edgar
this is to avoid adding another SPCO of the same gasket just with a different thickness, as it may cause issues with the material list in your isos.
[QUOTE=zion;106313]I assume this is using new bolting method.
AFAIK there is no control for the rounding of bolt length calculation, as it will always round up to the nearest bigger value in your bolt table.
I think you can play with the thickness of the gasket, use dataset for its default thickness value. then you can subtract the desparam from the thickness of the gasket to get the desired bolt length.
Cheers,
Edgar
this is to avoid adding another SPCO of the same gasket just with a different thickness, as it may cause issues with the material list in your isos.
