Report of PANE Length, Width & Height

Daniel Bruun over 12 years ago

Daniel Bruun over 12 years ago

Hi,

I would like to make a report of the PANE's dimensions, in Length, Width & Height.

I know that the height, i get the att HEIGHT, from the PLOO - but how do i get the Length & Width.

Best regards,

Daniel Bruun
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Brad Bennett over 12 years ago

I don't believe you will be able to. You could report out the PAVE's for each PLOO element but that won't give you just width and height. The PANE doesn't have a width or height to it since it can house as many vertices as you want.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Alan Shergold over 12 years ago

If the PANEL is rectangular you can get the height (LOHE), and use PSIZE which gives 2 values for the other 2 axes.

e.g.

at PANEL - Q LOHE PSIZE
or - Q PSIZE[1] & PSIZE[2]
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Felix Zamora over 12 years ago

thanks you for sharing this information..

cheers,
felix
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Daniel Bruun over 12 years ago

Thank you ajs,

The values i get is correctly length and height - example Lenght: 1220 mm Height: 2500 mm.

But, 50 % of the values i get Length and Height has been swapped - example Length: 2500 mm Height: 1220 mm.

Is there any way to write the command, so i get the correct values?

Br

Daniel Bruun
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Neil Darren Dryden over 12 years ago

It's dependant how the PANE wasmodeled.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Amit Barve over 3 years ago

I wish to extract surface of odd sized PLOO, I can find total surface are and thickness. But I need surface area of one side only .

TOTAL SURFACE AREA = (CIRCUMFERENCE x THICKNESS) + AREA OF ONE SIDE + AREA OF ANOTHER SIDE.

How can I find circumference of PLOO ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Corrado Galluzzi over 3 years ago in reply to Amit Barve

What about Q GVOL / LOHE ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Corrado Galluzzi over 3 years ago in reply to Corrado Galluzzi

Or maybe Q NVOL / LOHE

It is a rough calculation anyway...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Amit Barve over 3 years ago in reply to Corrado Galluzzi

VOl / HE gives area, not circumference. In my case polo have two circular openings. can Calculate can be calculated by geometry. But if getting circumference directly will be time saving.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel