Error 68 Severity 2

Has anyone seen the following error before?

GW4A32 GQUTXE
SEVERITY 2 ( FAILS ) ERROR 68 LOCATION FE

This repeats a few times, with the only difference being the last few characters of the GW4 line.

Can anyone advise where I should be looking to find the source of this error please.

It is an error from the TTF font. I believe that one of your sheets uses TTF but it has not been set up in Draft Admin. There is thread here about this. When I find it I will post the linkback.

Thanks Yar, sometimes the errors generated by PDMS are so obscure as to defy explanation.

Very confusing especially when some of them are so well documented.

This is what I found: http://www.pdmsworld.com/forum/t6507/

Link not found

http://52.178.132.139/showthread.php?t=6507