Editing Isometrics in draft

[QUOTE=Wolfie;73157]Hi Corrado,
Flange inclination tables are put on an iso when the flange in question has been site surveyed and seen to be out of square in N & S and E & W and up & down planes.

This is show so that the pipe fabricator knows how to weld the flange on so it mates up to the pipe on site
Cheers
Wolfie

Thank you Wolfie. This is what I expected....but I wanted to be sure before suggesting anything to you....

You could use Details in your Isometrics. And they can have "dynamic" texts inside (i.e. ORIentation attribute of flanges)
Hope you will find useful this: http://www.avevaworldusergroup.com/forum/showthread.php?t=11118

Cheers

[QUOTE=Wolfie;73157]Hi Corrado,
Flange inclination tables are put on an iso when the flange in question has been site surveyed and seen to be out of square in N & S and E & W and up & down planes.

This is show so that the pipe fabricator knows how to weld the flange on so it mates up to the pipe on site
Cheers
Wolfie

Thank you Wolfie. This is what I expected....but I wanted to be sure before suggesting anything to you....

You could use Details in your Isometrics. And they can have "dynamic" texts inside (i.e. ORIentation attribute of flanges)
Hope you will find useful this: http://www.avevaworldusergroup.com/forum/showthread.php?t=11118

Cheers