SDTE for an END-Plate on MDS/CATA

 

Hi!
Rtext ( 'Endplate - Lenght=' + STR ( ATTRIB DESP[1 ] ) + ' - Width=' + STR ( ATTRIB DESP[2 ] )  + ' - Thickness=' + STR ( ATTRIB DESP[3 ] ) )

( where [1] [2] [3] is your Key-Number in DTSE )

in Design:
q dtxr
Endplate - Lenght=100 - Width=200 - Thickness=10

if you want mm at the end of the values

Rtext ( 'Endplate - Lenght=' + STR ( ATTRIB DESP[1 ] ) + 'mm - Width=' + STR ( ATTRIB DESP[2 ] )  + 'mm - Thickness=' + STR ( ATTRIB DESP[3 ] ) + 'mm' )

q dtxr
Endplate - Lenght=100mm - Width=200mm - Thickness=10mm



Regards

Dear Joge,
Thanks a lot. It works well.
Regards