Move SPCO to different heading

Is there a speconmode way to move items from one heading to another?

Using the Spec form and removing to limbo then adding from limbo is painfully slow.

I need to move many blinds flanges from the flange heading to the blind heading in over 100 specs.

Top Replies

Corrado Galluzzi over 3 years ago +1

I think the following procedure is a little bit quicker than using Limbospec.... On the Command Window: SPECONMODE FILE /C:\TEMP\A150.TXT OUT OLD FLAN /A150 TERM Edit the resulting text file deleting…

Corrado Galluzzi over 3 years ago

I think the following procedure is a little bit quicker than using Limbospec....

On the Command Window:

SPECONMODE
FILE /C:\TEMP\A150.TXT
OUT OLD FLAN /A150
TERM

Edit the resulting text file deleting all the lines but the blind flange ones and find/replace FLAN type with FBLI.

Run the file back typing $M /C:\TEMP\A150.TXT on the Command Window.

Unfortunately you have to do it more than 100 times.

I have no better ideas.....I apologize....but I have just returned back from my holidays.... ;-)
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel
Cliff over 3 years ago in reply to Corrado Galluzzi

I was thinking along those lines as well.

Tried the syntax below but get a syntax error. Errors out at WI or WITH. Same when removing WITH.

Any ideas?

OUTPUT OLD FLAN WITH MATCHW (RTEX OF DETREF,'*FLANGE BLIND*') /A01
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
adak over 3 years ago in reply to Cliff

have you tried MATCHWILD ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Corrado Galluzzi over 3 years ago in reply to adak

WITH filter is not allowed in the syntax

...where <id> is the name or the refno of the SPEC
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel