I have placed support on pipeline through MDS.
Then after add weld on pipeline, each support need alignment required for iso extraction. otherwise iso's shows support is align with line.
And support realign its take lots time consuming activity.
kindly suggest me how i can skip this step.
and i have used E3D version 2.1.0.27[Z21027-23]
Best regards,
Mehul patel
Are you placing weld by command line?
I tried this approach by placing weld by component creation form and isometric is generating well without any errors.
I have placed support on pipeline through MDS.
Then after add weld on pipeline, each support need alignment required for iso extraction. otherwise iso's shows support is align with line.
And support realign its take lots time consuming activity.
kindly suggest me how i can skip this step.
and i have used E3D version 2.1.0.27[Z21027-23]
Best regards,
Mehul patel
Are you placing weld by command line?
I tried this approach by placing weld by component creation form and isometric is generating well without any errors.
