Spec Issue -bolting problem

Hi

Can anybody tell me how to modify boltref in specification
I want to change BOLTREF of perticular SPCO from machin bolt to stud bolt in existing specification
eg: /MMBBN TO /MSBBN

Navigate to the Speco in paragon
In command line Type BLTREF /MSBBN

Unless this is an AVEV supplied spec from MASTER, in which case you cannot change it

hi Pitch

Thanx for reply,

is it correct way to modify SPCO or we required to change this via specon module.

for the old bolting method it is done through specon.

Generally speaking in PDMS there is often more than one way to do lots of things, none of which can be said to be "right" or "wrong"

It does not matter which method is used as long as the result is correct.

hi Pitch

i used the method

"Navigate to the Speco in paragon
In command line Type BLTREF /MSBBN"

is it required to reselect flanges & valves?

as i am getting same bolt length after changing to /MSBBN.

There is no need to reselect.
You did however say you were changing the Bolt TYPE not length.
The length depends on the SBOLs in the MBOL