Error (33,700) No status flag for drawing

[QUOTE=JMcKenna1979;45799]Yes I did a consistency check on the pipes.  Perfectly consistent pipes, that was not the issue.

SOLUTION:  There is a DETAIL attribute at the Branch level of piping.  If this attribute is set to TRUE, isodraft will not run the iso unless[/U] you have the options file set to ignore this attribute.  The options file line which turns this on or off is as follows.
MARK IGNORE ON (or OFF)

Of course, this info is in the manuals, as it always is, but just took me some time to find, as per usual as well.  For info on this see the MARK command section in the ISODRAFT COMMAND REFERENCE MANUAL.

Thanks for the follow up and detailed solution!  It's really good for the forum to have in case anyone else has the same problem.

[QUOTE=JMcKenna1979;45799]Yes I did a consistency check on the pipes.  Perfectly consistent pipes, that was not the issue.

SOLUTION:  There is a DETAIL attribute at the Branch level of piping.  If this attribute is set to TRUE, isodraft will not run the iso unless[/U] you have the options file set to ignore this attribute.  The options file line which turns this on or off is as follows.
MARK IGNORE ON (or OFF)

Of course, this info is in the manuals, as it always is, but just took me some time to find, as per usual as well.  For info on this see the MARK command section in the ISODRAFT COMMAND REFERENCE MANUAL.

Thanks for the follow up and detailed solution!  It's really good for the forum to have in case anyone else has the same problem.