Pipe router automatically doesn't works!

Hello Friends,

I've created a Spec inwhich has TUBES, ELBOWS and others components, but when I use its on Desing Module I can't do pipe router automatically. Some erros appears such as:

Error whilist routing branch

(61,836) Cannot create bend/elbow after BRANCH 1 of PIPE 1 of ZONE

What i need to do?

Is it could be an error regarding a lack of COCO Table?

Does it work fine when you create components using the menus or with the Model Editor with this Spec?

Sometimes when I create components by menu Create I'm able to connect some pieces such as VALVS, ELBOWS and REDUCERS, but the pipe doesn't appear, only the traced line that connect the HREF and TREF.

Thanks

I'm having the same problem.
I tried to use a PDMS spec into my project to check if the problem was in the spec, but still not working.