GASKET NOT UPDATED IN NAVIS

Maybe the issue is related to the representation level of the geometry of the gasket in Catalogue?

Does the gasket geometry has the same representation level as the flange geometry in Catalogue?

Hi Emmanuel Desiderio , I have attached the screenshot with this message for your reference. these are the Geometry reference given for FLANGE and GASKET to its category. But it seems like the GMSE for the component is provided as Gmref. Is that right or the scom should be given as reference? Please advice

Your project setup seems different from ours.

In our setup, if the Tuflag attribute is unset, it should not appear in the 3D View in the Model.

I see...Okay let me confirm once and let you know. Then we can proceed further.

Hi Emmanuel Desiderio ...The gasket is not showing up in design model too. You're right

What can be the possible solution now? please advice

Above is the screenshot of my insulating gasket attributes. This is also not showing up in E3D Model.

I think that if you enable (or put a check) on the Tuflag attribute of the appropriate primitive/s, it should become visible in the 3D View of Model. It should also become visible in the exported Navis model.

For the insulating gasket, can you select its SCOM and send a screenshot of its attributes here?

sorry but please select the SCOM /ACGCBDGIN so we can see its attributes.
I want to check if your insulating gasket SCOM has Gmref /GMSE-INS or if it refers to another GMSE.
It is because I find it weird that the name of the CATE is very different from the name of its SCOM

No issues. Please find attached the screen shot for SCOM attributes. The project is near to end, the component was created 1 week back. so for easy identification, I have provided the name like that.

No issues. Please find attached the screen shot for SCOM attributes. The project is near to end, the component was created 1 week back. so for easy identification, I have provided the name like that.

It looks fine.

I am not sure what is the problem, but maybe this gasket can actually be seen in the 3D View?

Can you type Q DESGEO in the command window while this SCOM is selected?

The model elements that use this SCOM as CATR will appear.

Please copy the name of the model elements and paste it to the command window of Model Module to check if it is visible or not

Getting this error.

That means your insulating gasket is not yet used in the Model

For now, I would recommend you to make the Tuflag attribute enabled (or checked) in the gaskets that you are using.

After modification check if the modified gaskets are now visible in the 3D View in Model

Then check if they are also now appearing in navis

Okay got it. will enable that and check after included in model and NAVIS

Thankyou so much for your guidance. will let you know the output by EOD

And one small query.

I need to fetch the line items and all the provided properties for those. any macros for this?

or what method I can follow?

Do you mean you want to have a list of all piping that uses gaskets?

No. Actually the Sleeve that we use has no PDMS in NAVIS. As it is created under equipment.

FYR.

The requirement is this.

What modification should be done to show up the attributes in NAVIS for Equipments

Sorry, is this a new topic or are we still talking about the gasket?