I am trying to Create a Bolt spec and wanted to bolt details in Isometric extraction.
I created a Bolt Spec and given a Bolt spec reference to Pipe Spec, but still I can't see bolt details while extracting the ISO.
Here I followed the steps to create Bolt Details as below:
Just give me feed back where I went wrong
[COLOR=#0000ff]Step Wise:
1: NEW BLTA / NSB.BOLTS
2. NEW BLIS / NSB.#300.STUD
3. NEW SBOL / NSB.SBDD
Edit the Attributes as below mentioned
4. NEW LTAB /NSB.LTAB
5. NEW DTAB /NSB.M12
Attributes to be edited as below
Btlength unset - Blength (50 60 70 80 90 100)
6. Go to SBOL, and edit the attribute as below mentioned
Nstdblength nulref - NSB.M12
7. Go to Category "Flange"
create new BTSE
Here Bthickness parameter should be updated as, Falnge thickness Param , which we defined during Flange cata
8. Under BTSE, create BLTP, name as NSB.1
Attributes to be edited as below
NUMBER 0 - Number 1
Bdiameter - Bdiameter 12
Btype unset - Btype BOLT
Then stay at BLTP . 1
Create N No. of BLTP as per Bolt No.
9. Then go to FLANGE (Scom), need to Set Blrfarray as same BTSE name
10. bolt spec to be generated.
11. Go to Pipe Spec, select one,
Attributes to be edited as below:
BLTMETHOD - NEW
BSPEC - /NSB.#300.STUD.BOLT.SPEC (bolt spec name)[/COLOR]
I am trying to Create a Bolt spec and wanted to bolt details in Isometric extraction.
I created a Bolt Spec and given a Bolt spec reference to Pipe Spec, but still I can't see bolt details while extracting the ISO.
Here I followed the steps to create Bolt Details as below:
Just give me feed back where I went wrong
[COLOR=#0000ff]Step Wise:
1: NEW BLTA / NSB.BOLTS
2. NEW BLIS / NSB.#300.STUD
3. NEW SBOL / NSB.SBDD
Edit the Attributes as below mentioned
4. NEW LTAB /NSB.LTAB
5. NEW DTAB /NSB.M12
Attributes to be edited as below
Btlength unset - Blength (50 60 70 80 90 100)
6. Go to SBOL, and edit the attribute as below mentioned
Nstdblength nulref - NSB.M12
7. Go to Category "Flange"
create new BTSE
Here Bthickness parameter should be updated as, Falnge thickness Param , which we defined during Flange cata
8. Under BTSE, create BLTP, name as NSB.1
Attributes to be edited as below
NUMBER 0 - Number 1
Bdiameter - Bdiameter 12
Btype unset - Btype BOLT
Then stay at BLTP . 1
Create N No. of BLTP as per Bolt No.
9. Then go to FLANGE (Scom), need to Set Blrfarray as same BTSE name
10. bolt spec to be generated.
11. Go to Pipe Spec, select one,
Attributes to be edited as below:
BLTMETHOD - NEW
BSPEC - /NSB.#300.STUD.BOLT.SPEC (bolt spec name)[/COLOR]
