Actually I've tried to change SB thickness from 18 -> 17.9, ..., 17.2, 17.1
The bolt len in Isome drops on DTAB (170mm) when the SB thick. is less than 17.5mm
(if I set SB thick greater than 17.5mm, Isome will come out value 18 for SB)
but the MESC doesn't come out until I set SB thickness 17mm.
this time, the bolt len & MESC come out as i hope.
But, again, the problem is my boss doesn't accept it while he checks Isometric,
because he said the SB thickness is wrong, and the worker might confuse that.
(he means SB thick = 17mm)
Actually I've tried to change SB thickness from 18 -> 17.9, ..., 17.2, 17.1
The bolt len in Isome drops on DTAB (170mm) when the SB thick. is less than 17.5mm
(if I set SB thick greater than 17.5mm, Isome will come out value 18 for SB)
but the MESC doesn't come out until I set SB thickness 17mm.
this time, the bolt len & MESC come out as i hope.
But, again, the problem is my boss doesn't accept it while he checks Isometric,
because he said the SB thickness is wrong, and the worker might confuse that.
(he means SB thick = 17mm)
