[h=3]Sorry for the short answer...
I had a discussion with an experimented developer. I had same question.
He assured me, it was not technically possible.
Why? Because the Draft Engine does not support the JPG format (it's support only vectorial format)
So there is software for transpose a JPG format in DXF. But their softwares are not powerful enough (I only tried free)
[/h]
[h=3]Sorry for the short answer...
I had a discussion with an experimented developer. I had same question.
He assured me, it was not technically possible.
Why? Because the Draft Engine does not support the JPG format (it's support only vectorial format)
So there is software for transpose a JPG format in DXF. But their softwares are not powerful enough (I only tried free)
[/h]
