May be, I missed any procedure to Install MDS Support in E3D ?
Yes it could be possible.
Which procedure are you following?
From the documentation: The Pipe Specification Material Code value, for example, CS, represents the setting stored at a valid Pipe
specification, at the UDA :MDSPipeMat, for use by the Supports discipline.
May be, I missed any procedure to Install MDS Support in E3D ?
Yes it could be possible.
Which procedure are you following?
From the documentation: The Pipe Specification Material Code value, for example, CS, represents the setting stored at a valid Pipe
specification, at the UDA :MDSPipeMat, for use by the Supports discipline.
