I've always found that a bit messy and was wondering if there was any better method.
The specific issue I have is that the written specification calls for tubing/fittings with ODs of 6mm, 10mm and 12mm as well as NB pipe work at sizes 6mm, 8mm, 10mm & 15mm which gives me two clashes where the OD size is named the same as the NB despite there being a small physical difference in size and I was wondering if there was a better way of managing it that is less confusing for the designers.
As the majority of specs use the NB convention I'm very reluctant to change the NBRworld in a way that impacts on the NB components but can't come up with a sensible way to control the OD components within the same project.
I've always found that a bit messy and was wondering if there was any better method.
The specific issue I have is that the written specification calls for tubing/fittings with ODs of 6mm, 10mm and 12mm as well as NB pipe work at sizes 6mm, 8mm, 10mm & 15mm which gives me two clashes where the OD size is named the same as the NB despite there being a small physical difference in size and I was wondering if there was a better way of managing it that is less confusing for the designers.
As the majority of specs use the NB convention I'm very reluctant to change the NBRworld in a way that impacts on the NB components but can't come up with a sensible way to control the OD components within the same project.